NOTE: Even though the FUNCTION buttons are labelled for specific components, they can be programmed to operate any type of equipment that is compatible with this remote control. For example, the BD/DVD function can be programmed to operate a VCR, AV receiver, etc.
Turn on the component to be programmed.
On the remote control, press and hold the function button for the component being programmed.
While holding appropriate function button, press the INPUT button for the desired component.
Release both buttons.
NOTE: The FUNCTION button will blink for approximately 30 seconds or until a code is entered.
Using the number pad, enter the component's manufacturer code.
NOTE: If more than one code number is listed for the manufacturer, enter one code at a time until you find one that works.
Press the ENT button.
NOTE: The FUNCTION will blink twice if the programming is successful, if not, it will blink five times.
Point the remote control at the component.
Press the component POWER button to verify operation.
If a new code number is entered, the code number previously entered will be erased.
When the batteries are replaced, the programmed codes may be erased. It may be necessary to reprogram the remote after replacing the batteries.
Some product functions may not be able to be controlled by the remote control. Use the remote control provided with the component.
In some rare cases, you may not be able to operate your non-Sony equipment with the supplied remote control. This is because your equipment may use a code that is not provided with this remote control. In this case, use the remote control that was provided with the equipment or purchase a universal remote control that has a learning function.
If programming fails, it may be necessary to reset the remote control. To reset the remote control, remove the batteries and press each button on the remote control twice.