Skip to the end of navigation

Remote Codes and Programming Instructions


Programming instructions for this remote are shown at the bottom of this page.

Select the brand name from the drop down list for each component for which you want to see codes.



Code Choices


Programming Instructions

Follow these steps to program the remote control.

  1. Turn on the VCR to be programmed.
  2. On the remote control, move the PIP/VTR switch to VCR.
  3. Move the VTR 1/2/3/MDP switch to VTR 2.
  4. Press and hold the CODE SET button.
  5. While holding the CODE SET button, enter the manufacturer code number using the number pad.
  6. Release the CODE SET button.


  • When the batteries are replaced, the programming may be erased. It may be necessary to reprogram the remote after replacing the batteries.
  • The operation of a combination deck of any kind is not guaranteed.
  • Some product functions may not be able to be controlled by the remote control. Use the remote control provided with the component.
  • In some rare cases, you may not be able to operate your non-Sony equipment with the supplied remote control. This is because your equipment may use a code that is not provided with this remote control. In this case, use the remote control that was provided with the equipment or purchase a universal remote control that has a learning function.
  • If programming fails, it may be necessary to reset the remote control. To reset the remote control, remove the batteries and press each button on the remote control twice.