Use the TV as a monitor for your PC by connecting an HD15-HD15 cable connection as shown below. This TV can also be connected to a PC with a DVI or HDMI output. (Refer to the Quick Setup Guide supplied with the TV.)

  • Connect the PC IN jack to the PC using an HD15-HD15 cable with ferrite core (analog RGB) and audio cable.
  • The TV enters the standby mode automatically when the PC is connected to the TV and no signal has been output from the PC for more than 30 seconds.

PC Input Signal Reference Chart

After connecting the PC to the TV, set the output signal from your PC according to the supported resolutions and timings indicated below.

 Supported Resolutions Horizontal
frequency (kHz)
frequency (Hz)
 Signal Horizontal (Pixel) x Vertical (Line)
VGA 640 x 480 31.5 60 VGA
SVGA 800 x 600 37.9 60 VESA Guidelines
XGA 1,024 x 768 48.4 60 VESA Guidelines
WXGA 1,280 x 768 47.4 60 VESA
1,280 x 768 47.8 60 VESA
1,360 x 768 47.7 60 VESA
SXGA 1,280 x 1,024 64.0 60 VESA
HDTV* 1,920 x 1,080 67.5 60 CEA-861*

  • This TV’s PC input does not support Sync on Green or Composite Sync.
  • This TV’s PC VGA input does not support interlaced signals.
  • For the best picture quality, it is recommended to use the signals in the above chart. In plug and play, signals with a 60 Hz vertical frequency will be detected automatically. (PC reboot may be necessary.)
  • Phase and Pitch options are not available with PC signal connected to HDMI input.

*The 1080p timing when applied to the HDMI input will be treated as a video timing and not PC timing. This affects Picture
  settings, and Wide Mode settings. To view PC content set Scene Select to Graphics, Wide Mode to Full, and Display Area to Full Pixel.

Back to HD Cable Box/HD Satellite Box Next to Connecting Internet & DLNA Certified™ Networks