REMOTE CODES & PROGRAMMING INSTRUCTIONS

RM-ANP003

Programming instructions for this remote are shown at the bottom of this page.

Select the brand name from the drop down list for each component for which you want to see codes.

Component

Brand

Code Choices

Cable Box
 
Digital Satellite receiver
 

Programming Instructions

Follow these steps to program the remote control.

  1. Turn on the component to be programmed.
  2. On the remote control, simultaneously press and hold the FUNCTION button for the component to be programmed and the POWER button
  3. Release both buttons.
  4. NOTE: The selected FUNCTION button will flash.

  5. Enter the television manufacturer code number using the number pad.
  6. NOTE: If more than one code number is listed for the manufacturer, enter one code at a time until you find one that works.

  7. Point the remote control at the component.
  8. Press the POWER button to verify operation.

NOTES:

  • If a new code number is entered, the code number previously entered will be erased.
  • When the batteries are replaced, the programmed codes may be erased. It may be necessary to reprogram the remote after replacing the batteries.
  • The operation of a combination deck of any kind is not guaranteed.
  • Some product functions may not be able to be controlled by the remote control. Use the remote control provided with the component.
  • In some rare cases, you may not be able to operate your non-Sony equipment with the supplied remote control. This is because your equipment may use a code that is not provided with this remote control. In this case, use the remote control that was provided with the equipment or purchase a universal remote control that has a learning function.
  • If programming fails, it may be necessary to reset the remote control. To reset the remote control, remove the batteries and press each button on the remote control twice.