Follow these steps to program the remote control.
IMPORTANT: This remote control is only programmable using the learn function and does not have any manufacturer programming codes.
- Place the receiver remote control on a flat surface.
- Place the remote control of the device to be controlled, head-to-head, and approximately 2 inches from the remote control being programmed.
- On the receiver remote control, set the mode selector to LEARN.
- Press the appropriate FUNCTION button for the equipment being programmed.
- Press and hold the button to be taught until the LEARN indicator lights up.
- On the other remote control, press and hold the button to be learned until the LEARN indicator on the amplifier remote goes off.
- Release both buttons.
NOTE: Repeat steps 4, 5, 6, and 7 for any other buttons that you may want to program.
- Set the mode selector to USER STD or SONY STD.
- When the batteries are replaced, the programming may be erased. It may be necessary to reprogram the remote after replacing the batteries.
- Some product functions may not be able to be controlled by the remote control. Use the remote control provided with the component.