Skip to the end of navigation

Remote Codes and Programming Instructions


Programming instructions for this remote are shown at the bottom of this page.

No remote codes are currently available online for the RM-P331.

Remote codes are often listed in the product manual, so it is recommended you check there.

Note: If this remote came with another Sony product (e.g. TV, DVD, etc...), the remote codes may be listed in the manual for that product.

Programming Instructions

Follow these steps to program the remote control.

IMPORTANT: This remote control is only programmable using the learn function and does not have any manufacturer programming codes.

  1. Place the receiver remote control on a flat surface.
  2. Place the remote control of the device to be controlled, head-to-head, and approximately 2 inches from the remote control being programmed.
  3. On the receiver remote control, set the mode selector to LEARN.
  4. Press the appropriate FUNCTION button for the equipment being programmed.
  5. Press and hold the button to be taught until the LEARN indicator lights up.
  6. On the other remote control, press and hold the button to be learned until the LEARN indicator on the amplifier remote goes off.
  7. Release both buttons.
  8. NOTE: Repeat steps 4, 5, 6, and 7 for any other buttons that you may want to program.

  9. Set the mode selector to USER STD or SONY STD.


  • When the batteries are replaced, the programming may be erased. It may be necessary to reprogram the remote after replacing the batteries.
  • Some product functions may not be able to be controlled by the remote control. Use the remote control provided with the component.