REMOTE CODES & PROGRAMMING INSTRUCTIONS

RM-TP2

Programming instructions for this remote are shown at the bottom of this page.

No remote codes are currently available online for the RM-TP2.

Remote codes are often listed in the product manual, so it is recommended you check there.

Note: If this remote came with another Sony product (e.g. TV, DVD, etc...), the remote codes may be listed in the manual for that product.

Programming Instructions

Follow these steps to program the remote control.

IMPORTANT: The numeric codes are not provided for this model because the frequencies are built in to the remote control and display during the programming process.

  1. On the remote control, touch RM SELECT.
  2. Touch the function for the component to be programmed.
  3. Touch the toolbox icon.
  4. Touch IR SETUP.
  5. Touch the component category.
  6. Touch the manufacturer and command mode for the component.
  7. NOTE: If more than command mode is listed for the manufacturer, touch one code at a time until you find one that works.

  8. Touch EXIT or CANCEL.

NOTES:

  • If a new code number is entered, the code number previously entered will be erased.
  • When the batteries are replaced, the programmed codes may be erased. It may be necessary to reprogram the remote after replacing the batteries.
  • The operation of a combination deck of any kind is not guaranteed.
  • Some product functions may not be able to be controlled by the remote control. Use the remote control provided with the component.
  • In some rare cases, you may not be able to operate your non-Sony equipment with the supplied remote control. This is because your equipment may use a code that is not provided with this remote control. In this case, please use the equipment's own remote control.