Follow these steps to program the remote control.

NOTE: Even though the FUNCTION buttons are labelled for specific components, they can be programmed to operate any type of equipment that is compatible with this remote control. For example, the BD/DVD function can be programmed to operate a VCR, AV receiver, etc.

1. Turn on the component to be programmed.
2. On the remote control, press and hold the appropriate FUNCTION button for the type of component being programmed.
3. While holding the FUNCTION button, press the DISPLAY button.
4. Release the FUNCTION and DISPLAY buttons.

NOTE: The FUNCTION button will flash.

5. Using the number pad, enter the component's manufacturer code.

NOTE: If more than one code number is listed for the manufacturer, enter one code at a time until you find one that works.

6. Press the ENT button.
7. Point the remote control at the component.
8. Press the appropriate component POWER button to verify operation.

NOTES:

• If a new code number is entered, the code number previously entered will be erased.
• When the batteries are replaced, the programmed codes may be erased. It may be necessary to reprogram the remote after replacing the batteries.
• The operation of a combination deck of any kind is not guaranteed.
• Some product functions may not be able to be controlled by the remote control. Use the remote control provided with the component.
• In some rare cases, you may not be able to operate your non-Sony equipment with the supplied remote control. This is because your equipment may use a code that is not provided with this remote control. In this case, use the remote control that was provided with the equipment or purchase a universal remote control that has a learning function.
• If programming fails, it may be necessary to reset the remote control. To reset the remote control, remove the batteries and press each button on the remote control twice.